Install The Air Line Accessories; Install The Gun And Mounting Bracket - Graco PRO Auto Xs Instructions-Parts List Manual

Installation

Install the Air Line Accessories

1. Install a bleed-type air valve (L) on the main air line
(W) to shut off all air to the gun (H).
2. Install an air line filter/water separator on the gun air
line to ensure a dry, clean air supply to the gun. Dirt
and moisture can ruin the appearance of your fin-
ished workpiece and can cause the gun to malfunc-
tion.
3. Install a bleed-type air regulator (M) on each of the
air supply lines (B, C, D, E, X, Y) to control air pres-
sure to the gun.
4. Install a solenoid valve (K) on the cylinder air line (E)
to actuate the gun. The solenoid valve must have a
quick exhaust port.
WARNING
Pressurized Equipment Hazard
Trapped air can cause the gun to spray
unexpectedly, which can result in serious
injury, including splashing fluid in the eyes
or on the skin. The solenoid valves (K) must
have a quick exhaust port so trapped air will
be relieved between the valve and gun
when the solenoids are shut off.
12
Install the Gun and Mounting
Bracket
1. Loosen the mounting bracket's two set screws (103)
and slide the bracket (102) onto a 1/2 in. (13 mm)
mounting rod. See F
2. Position the gun and tighten the two set screws.
NOTE: For added positioning reliability, insert a 1/8 in.
(3 mm) locating pin into the slot (NN) in the bracket and
through a hole in the rod. See the detail in F
102
103
NN
03460
Fig. 4. Mounting Bracket
. 4.
IG
. 4.
IG
2.88 in
(73.2
To
9.22 in
TI1570A
nozzle
(234.2
309457G