Clean The Gun And Gun Filter - Graco MAGNUM TRUEAIRLESS Project Painter Plus Owner's Manual

Cleanup
c. Lower Prime/Spray Valve to
SPRAY position (C).
d. Turn ON/OFF switch to ON position
(D).
e. Continue to hold gun trigger until
you see paint diluted with flushing
fluid starting to come out of gun.
15. While continuing to trigger gun, quickly
move gun to redirect spray into waste
pail. Continue triggering gun into waste
pail until flushing fluid dispensed from
gun is relatively clear.
16. Turn pressure control knob to the low-
est setting.
17. Stop triggering gun. Engage the trigger
lock.
26
18. Lift Prime/Spray Valve to PRIME posi-
tion.
19. Turn ON/OFF switch to OFF position.
20. Follow Short Term Storage or Long
Term Storage, page 27.
Clean the Gun and Gun
Filter
1. Perform Pressure Relief Procedure,
page 14.
2. Remove the gun handle by unscrewing
the handle from the gun head.
3. Clean gun filter with water or flushing
fluid and a brush every time you flush
the system. Replace gun filter if dam-
aged.
4. Remove Spray Tip Guard assembly and
clean with water or flushing fluid and a
brush.
5. See Spray Tip Installation, page 21 to
properly reinstall Spray Tip Guard
assembly.
6. Wipe paint off outside of gun using a soft
cloth moistened with water or flushing
fluid.
3A6430C EN