Label Tear-Off - SATO CX200 Programming Manual

CX200 Programming Guide
Command Structure
Command Function
Input to Printer
Printer Output
Special Notes
SATO CX200 Printers

Label Tear-Off

<ESC>CBabb
Example: <ESC>CB+03
a =
bb =
Placement: This command should be sent in a separate data stream.
Default: Last valid setting.
To adjust the location of the first print line on the label.
<ESC>A
<ESC>CI2<ESC>CB+03
<ESC>Z
There is no printer output for this command. The first print line on the
next printed label will be adjusted after the receipt of this command.
1. The effects of this command are cumulative, i.e. if an <ESC>CB+06
command is followed by an <ESC>CB-02, the resulting change in
position is +4mm.
2. The maximum range for the value stored in the printer is 98mm.
Any commands received that cause the value to exceed 00 or 98
will result in a setting of 00 or 98 respectively.
3. The value is stored in flash memory and will remain until it is
modified by another valid <ESC>CBabb command, even if power
is removed from the printer.
4. The current setting is printed out on the "Pitch Offset" line on the
test label. This setting is referenced to the sensor position which
is located 0.75" (19mm) from the first print line (V=000)
5. Separate offset settings are stored for gap and eye-mark sensing.
PN 9001055 Rev. E
+ to move the print line down from the top
edge of the label
- to move the print line toward thetop of the
label
Distance moved in millimeters (00 to 25)
Page 89