Rotated Fields - SATO CX200 Programming Manual

Original image must be moved towards
the left (facing the printer) to make it
print on a 2" wide label.
The image reference point is set at the left edge (facing the printer) of the label so
that it can be printed on a 2 inch wide label.
Note: The printers will not "wrap" images that extend beyond the print area. If any part
of a character or image extends beyond the print area, it will disappear.
For more information, see the Base Reference Point command description.

ROTATED FIELDS

The printers can rotate each print field in 90° increments using the Rotate command.
There are two variations of this command.
<ESC>% - The field rotates, but the base reference point for the field
remains the same.
<ESC>R - The field and the base reference point rotate.
The following data stream will rotate the print field but will not change the base
reference point of the field:
<ESC>A<ESC>%1<ESC>V800<ESC>H200<ESC>L0202<ESC>WB1E<ESC>Q1<ESC>Z
The following data stream will rotate both the field and the base reference point for
that field:
<ESC>A<ESC>R<ESC>V0200<ESC>H0100<ESC>L0202<ESC>P02<ESC>WB1E<ESC>Q1<ESC>Z
SATO CX200 Printers
SATO
*SATO*
*SATO*
SATO
4.1"
PN 9001055 Rev. E
CX200 Programming Guide
SATO
*SATO*
*SATO*
SATO
2" Label
Page 7