SATO CX200 Programming Manual page 24

CX200 Programming Guide
Special Notes
Page 20
1. Use of this command will set the Vertical/Horizontal Offset setting of
the printer configuration until a new Base Reference Point
command is issued.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your
current Horizontal and Vertical Print Position commands (see
Page 53).
Example:
Let's say the current base reference point is H=1, V=1 and you
wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point
command, see "Print Area" in this section (Page 4).
5. The CX200 printers will not "wrap" (i.e. if any part of a character or
image extends beyond the last print dot position, it will disappear
and not be visible on any part of the label).
PN 9001055 Rev. E
SATO CX200 Printers