SATO CX200 Programming Manual page 2

Technical Support Hot Line: (704) 644-1660
Warning: This equipment has been tested and found to comply with the limits for a
Class B computing device pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed in accordance with the instruction may cause
harmful interference to radio communications.However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet or a circuit different from that to
which the receiver is connected.
Consult an experienced radio/TV technician for help.
Caution: The FCC warns the users that changes or modifications of the unit not
expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
All rights reserved. No part of this document may be reproduced or issued to third
parties in any form whatsoever without the express permission of SATO America, Inc.
The material in this document is provided for general information and is subject to
change without notice. SATO America, Inc. assumes no responsibility for any errors
that might appear.
SATO America, Inc.
10350-A Nations Ford Rd.
Charlotte, NC 28273
Main Phone: (704) 644-1650
Fax: (704) 644-1661
http://www.satoamerica.com
© Copyright 1998
SATO America, Inc.