Detach Two Connected Half-Width Switches - NETGEAR M4350 Series Hardware Installation Manual

6. Align the mounting holes in the brackets (on the left of the left switch and on the
right of the right switch) with the holes in the rack, and depending on the rack, insert
the medium-sized or large screws through each bracket and into the rack.
• Flush-mounting example
• Set-back mounting example
7. Tighten the screws with a No. 2 Phillips screwdriver to secure the brackets to the
rack.

Detach two connected half-width switches

After you detach and remove two connected half-width switches from a rack, follow the
steps in this procedure to detach the switches from each other.
Installation
Fully Managed Switches M4350 Series
60 Hardware Installation Guide