Place The Switch On A Flat Surface; Optional Step 5: Install Fiber Transceiver Modules - NETGEAR M4350 Series Hardware Installation Manual

Place the switch on a flat surface

The switch ships with four self-adhesive rubber footpads.
To place the switch on a flat surface:
Stick one rubber footpad on each of the four concave spaces on the bottom of the
switch.
The rubber footpads cushion the switch against shock and vibrations. They also
provide ventilation space between stacked switches.
Optional Step 5: Install fiber transceiver
modules
This procedure is optional.
For information about the fiber transceiver modules, see Fiber transceiver modules and
cables for SFP+ and SFP28 ports on page 37.
The following procedure describes how to install an optional fiber transceiver module
into one of the SFP+ or SFP28 ports of the switch.
To install an SFP+ or SFP28 transceiver module:
1. Insert the transceiver module in an SFP+ or SFP28 port.
2. Press firmly on the flange of the transceiver module to seat it securely into the
connector.
Installation
Fully Managed Switches M4350 Series
62 Hardware Installation Guide