NETGEAR M4350 Series Hardware Installation Manual page 52

1
2
3
Figure 16. Package contents for an M4350 series half-width model
To check the package contents:
1. Place the container on a clean flat surface, and cut all straps securing the container.
2. Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4. Verify that the package contains the following items:
Number Item
1 Switch of the model that you ordered
Note: Rubber protection caps are installed in the SFP sockets. If you install an SFP transceiver
module, you must remove the cap from the SFP socket.
2 AC power cable or cables (varies by region)
3 Type-C USB console cable
Installation
Fully Managed Switches M4350 Series
4
7
8
52
6
5
9
10
Hardware Installation Guide