Transportation - Dimplex LA 60P-TUR Installation And Operating Instruction

English
5

Transportation

CAUTION!
The heat pump must not be tipped during transportation. The
machine must be secured to prevent the risk of tipping.
CAUTION!
Never install the device in rooms in which there are any
permanent ignition sources.
CAUTION!
The device contains R290 (propane). The device is designed
exclusively for outdoor installation. Avoid ignition sources in
the safety zone!
The casing must remain closed!
CAUTION!
It is prohibited to remain in the direct vicinity of the device
during storms (risk of lightning)!
CAUTION!
If the device falls or is subject to impact load during transport,
the device must be checked immediately for leakages. If an
outflow noise can be heard, if oily surfaces form or if a leakage
is detected with a detector, the refrigerant must be drained
off by an authorised person. Ignition sources in the area
around the device must be avoided until the draining is safely
completed. If the leakage occurs inside a building, the
affected area must be ventilated immediately.
Repair leakages on-site where possible or return the device to
the factory for repair.
Transportation, including all related activities such as lifting,
loading, lowering, unloading and unpacking, must be carried
out by trained personnel.
The transport routes must be cleared and suitable agents must
be spread if necessary (for defrosting or increasing grip).
Only use suitable transport equipment.
Personal protective equipment must be used when transport-
ing and removing the transport packaging in accordance with
German Social Accident Insurance (DGUV) regulation 100-500
Sec. 2.35
A pallet should be used for transportation to the final installa-
tion location. The basic device can be transported with a lift
truck, forklift or a crane. The device must only be lifted from the
operator side.
When lifting via a crane, observe the load bearing capacity of
the lifting gear, see German Social Accident Insurance (DGUV)
regulation 100-500 Sec. 2.8.
Slinging cords (rope suspensions) in accordance with EN
13414 or slinging chains (chain suspensions) in accordance
with DIN 5687/5688 must be used. It should be ensured that
there is a symmetrical load; the conditions necessary for this
such as having the same rope/chain length and angle of incli-
nation must be met. Minimum distances in accordance with EN
349 must be observed. After the crane transport, the transport
eyebolts must be removed and the openings closed with the
vent plugs supplied.
EN-6
After transportation, the transport fastening in the device is to
be removed from both sides of the base.
NOTE
Before commissioning, the transport fastening must be
removed.
452167.66.42 · FD 0008
LA 60P-TUR
Remove/screw in
transport lock (4x)
www.glendimplex.de