Roland VS-2000 Owner's Manual Addendum page 73

Aux and FX Bus Parameters
1. PRE/POST Switch
Click the PRE/PST switch to configure the Aux and FX bus to accept
channel signals from before or after the channel faders.
2. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click the AUTOMIX STATUS button to
set the Aux and FX bus's Automix status.
3. Linked Aux and FX Bus Balance
When an odd/even pair of Aux and FX busses is linked, this knob become
active (see below) and allows you to set the relative levels of the linked
busses.
4. Aux and FX Bus Master Level
Drag this knob up or down to set the master level of the Aux and FX bus.
5. LINK
To link or un-link odd/even Aux bus and/or FX bus pairs, click the LINK
button so it lights. When two Aux and/or FX busses are linked, their
appearance changes onscreen to reflect their combined operation as shown to
the right. Their Aux and FX send sliders in the various channel views and the
track controls also change—the odd-numbered slider sets the send level, and
the even-numbered slider becomes a panning handle that allows you to pan
signals between the two linked busses.
Roland VS-2000 Owner's Manual, Version Two Addendum
Mixer view
Panning
handle
7—Mixer Views
Track controls
www.RolandUS.com
1.
2.
3.
4.
5.
73