Working With The Meters Strip - Roland VS-2000 Owner's Manual Addendum

5—VGA Main Display Home Screen
•
•
•
The number of active FX return channels depends on how many VS8F-2 effect
Expansion Boards or VS8F-3 Plug-in Expansion Boards are installed in your VS-2000.
See Owner's Manual Page 55.
Track Channel Meters TRACK STATUS Buttons
You can click the small button beneath a track channel meter to set the
corresponding hard disk recorder track's status—the button acts just like
a TRACK STATUS button on the VS-2000, described on Owner's Manual
Page 176.
The MONITOR and MASTER Meters
The stereo MONITOR and MASTER bus output levels are
displayed at the right of the meters strip except when the input or
output meters are visible.

Working with the Meters Strip

Reading a Meter
Each meter in the meter strip contains a vertical stack
of segments that light to show the corresponding
signal's level—the higher the stack, the louder the
signal. The segments are color-coded to help you see at
a glance how loud your signal is. If a signal exceeds
0dB, the meter's OVER indicator lights to show you that
the signal's too loud.
42 www.Roland.com
fx return channel levels—signals as they exit the VS-2000's internal effect processors.
Aux, FX and Direct path levels—the two Aux master six FX master, and eight Direct
paths.
output levels—signals as they exit the VS-2000's output jacks and connectors.
Roland VS-2000 Owner's Manual, Version Two Addendum
OVER Red —indicates
indicator that the signal is
approaching 0dB.
Yellow —warns
that you're
nearing the red
area.
Green —shows
that signal is
present.