Swing Gate Replacement; Remove Swing Gate - Ariens Power Brush 28 Service Manual

See Figure 29.
6. Reinstall spring clips into hex shaft.
1. Pinion Sprocket
2. Spring Clip
7. Reinstall bottom cover and secure with six hex bolts.
8. Position axle keys and reinstall wheels. Secure
wheels with snap clips.
9. Rotate tractor to operating position, support handlebar
and reinstall brush assembly. See Install Brush to
Frame on page 9.
10. Adjust speed selector lever. Refer to Operator's
Manual for adjustment procedure.
11. Fill fuel tank and reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
1
2
Figure 29

SWING GATE REPLACEMENT

Remove Swing Gate

IMPORTANT: Save all hardware for reinstallation.
1. Turn engine key to off position, remove key and close
fuel valve.
2. Wait for all moving parts to stop and for hot parts to
cool.
3. Disconnect spark plug wire.
4. Remove traction drive belt. See Remove Traction
Drive Belt on page 12.
See Figure 30.
5. Remove hardware retaining traction drive clutch cable
end to swing gate and remove cable.
EN – 18
Figure 30