Swing Gate Replacement; Remove Swing Gate - Ariens Sno-Thro Professional Series Service Manual

See Figure 39.
3. Reinstall bearing onto hex shaft end.
4. Reinstall bearing flange over bearing and secure to
frame with three tapping screws.
5. Reinstall spring clips into hex shaft.
6. Reinstall adjustment pivot pin onto shift arm and
secure with hairpin.
7. Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
8. Reinstall axle keys and wheels onto axle and secure
with snap clips.
9. Return unit to operating position.
10. Fill fuel tank and reconnect spark plug wire.
11. Adjust speed selector lever. Refer to Operator's
Manual for adjustment procedure.
IMPORTANT: Check all adjustments after first use.
Figure 39

SWING GATE REPLACEMENT

Remove Swing Gate

NOTICE: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Under control panel, remove hairpin, washer and
spring retaining upper traction clutch cable to clutch
lever and disconnect cable. See Figure 40.
EN – 23
Figure 40