Hex Shaft Bearing Replacement; Remove Bearing; Install Bearing; Swing Gate Replacement - Ariens Sno-Thro Deluxe 24 Service Manual

HEX SHAFT BEARING REPLACEMENT

Remove Bearing

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
See Figure 36.
3. Remove hardware retaining bearing flange to frame
and remove flange.
4. Remove bearing from hex shaft.
1
1. Bearing Flange
2. Bearing
3. Hex Shaft

Install Bearing

1. Install bearing onto hex shaft end.
2. Install bearing flange over bearing and secure to
frame with three tapping screws.
2
3
Figure 36

SWING GATE REPLACEMENT

Remove Swing Gate Assembly

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove auger housing. See Separate Housing From
Frame on page 7.
4. Remove traction drive belt. See Remove Traction
Drive Belt on page 14.
See Figure 37.
5. Position tractor / frame on a support, such as wood
blocks, so wheels are off the ground. Make sure unit is
secure and will not tip.
6. Remove snap clip from axle ends and remove wheels.
EN – 20
Figure 37