FRICTION DISC REPLACEMENT
Remove Friction Disc
IMPORTANT: Save all hardware for reinstallation.
WARNING: AVOID INJURY. Before rotating unit
forward, drain fuel from tank and fuel system.
See Draining Fuel System on page 7. Ensure
that unit is secure and will not tip.
1.
Turn engine key to off position, remove key and close
fuel valve.
2.
Wait for all moving parts to stop and for hot parts to
cool.
3.
Disconnect spark plug wire.
4.
Separate brush from frame and remove bottom cover.
See Separate Brush From Frame on page 7 and
Bottom Cover Removal on page 10.
5.
Remove snap clips from axle ends and remove
wheels and axle keys. Take care not to lose axle keys.
See Figure 22.
Figure 22
6.
Remove hairpin from adjustment pivot pin and remove
pin from shift arm. See Figure 23.
7.
Remove spring clips from hex shaft. See Figure 24.
EN – 16
Figure 23
Figure 24