Install Brush To Frame - Ariens Power Brush 28 Service Manual

WARNING: ALWAYS support tractor / frame
when loosening hardware retaining it to brush
attachment.
See Figure 7.
10. Position support under handlebar so tractor / frame
will not tip when disconnected from brush attachment.
11. Chock or block wheels to prevent tractor / frame
movement when separated from brush attachment.
See Figure 8.
12. Remove hardware retaining brush attachment to
tractor / frame.
13. Lift up and out to separate brush attachment from
tractor / frame.
1. Mount Rod
2. Tapping Screw
Figure 7
2
1
Figure 8

INSTALL BRUSH TO FRAME

1. Reinstall brush attachment mount bracket onto mount
rod. See Figure 9.
2. Secure brush attachment to frame with four tapping
screws and torque to 19.7 N•m – 26.4 N•m (14.5 lb-ft –
19.5 lb-ft).
WARNING: AVOID INJURY. Engine sheave
edges are sharp. Wear thick gloves when guiding
belts onto engine sheave.
3. Reinstall attachment belt onto engine sheave.
To assist belt reinstallation, slowly pull recoil starter handle
while guiding belt into engine sheave.
4. Secure belt finger to engine with two flat steel
washers, two locking washers and two hex bolts.
EN – 9
Figure 9