Rimage Autostar II User Manual page 14

Rimage Autostar II and Protégé II
b. If the disc is not centered side-to-side
on the print pad, align the printer side
to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the tray, until
the side edges of the disc and
printer pad are aligned.
iii. Tighten the side to side screws.
c. Using either the T25 Torx driver or the 5/32" Allen wrench, turn the front to back
alignment screw until the disc hangs over the edge of the print pad by 0.010" -
0.015".
5. Raise the lift arm to the top the unit.
6. To close the print tray, press the printer button.
7. To release the disc from the gripper, press the disc release button.
Tip: Place your hand under the disc to catch it.
8. Close the door.
10
Side to Side Screws
Front to Back
Alignment Screw
110629_F