Introduction
Introduction
Note: The term Producer II applies to both the Autostar II and the Protégé II. Autostar II and
Protégé II will be used only to refer to either Producer II specifically.
This manual provides the information needed to operate the Autostar II or the Protégé II and
identify the parts. To setup and install your Producer II, refer to the Autostar II and Protégé II
Setup and Installation Guide.
The Producer II is available with either the Everest Printer or the PrismPlus Printer.
Autostar II
Protégé II
Requirements
Software requirements
The Producer II will operate only with the Rimage Producer Software.
Operating system requirements
The Producer II runs on Windows 2000 SP4, Windows XP SP1 or SP2, and Windows 2003.
Media requirements
Refer to your Everest Printer User Guide or PrismPlus! Printer User Guide for the correct media
requirements.
Ribbon requirements
Refer to your Everest Printer User Guide or PrismPlus! Printer User Guide for the correct printer
ribbons.
Label design requirements
Refer to your Everest Printer User Guide or PrismPlus! Printer User Guide for label design
requirements.
Networking ability
To submit orders from a networked PC, refer to the Rimage Advanced Setup Guide.
110629_F
1