Installing Options - Ricoh AP600N Setup Manual

R CAUTION:
• Be sure to turn off the printer and wait for about an hour before installing
options. Not waiting for the printer to cool down can result in a burn.
• When lifting the printer, use the inset grips on both sides of the printer, oth-
erwise the printer might fall and cause personal injury.
• When you move the printer, unplug the power cord from the wall outlet to
avoid a fire or an electric shock.
Important
❒ The voltage rating of the connector for options is 24 V DC or less.
❒ Turn the power off before removing the Paper Feed Unit Type 600, 1-bin Shift
Sort Tray Type 2600, or Mailbox CS380. Removing any of these units with the
power on may cause the printer to fail.
❖ ❖ ❖ ❖ Option List
• Paper Feed Unit Type 600
• Envelope Feeder Type 2600
• 1-bin Shift Sort Tray Type 2600
• CS380 (Mailbox)
• AD410 (Duplex Unit)
• Memory Unit Type C (SDRAM Module)
• Hard Disk Drive Type 2600
• 1394 Interface Unit Type 4510
• 802.11b Interface Unit Type A
• Bluetooth Interface Unit Type 2045
*1
These cannot be attached at the same time.
Note
❒ A maximum of two Paper Feed Units can be attached to the printer at the
same time.
❒ The installation of the Paper Feed Unit is necessary to attach the Envelope
Feeder Unit.
❒ Either one of the 1-bin Shift Sort Tray or the Mailbox can be attached to the
printer.
❒ You must install additional Memory Units to use the 1394 Interface Unit
and Bluetooth Interface Unit.

2. Installing Options

*1
*1
*1
19