Ricoh AP600N Setup Manual page 18

Getting Started
4.
Output Tray Extension
Pull out this extension when printing
on long paper.
5.
Control Panel
1
Contains keys for the printer opera-
tion and a panel display that shows
the printer status.
6.
Output Tray (Standard Tray)
Printed output is stacked here with
the print side facing down.
7.
Upper Cover
Remove to install the optional 1-bin
Shift Sort Tray or the optional Mail-
box.
8.
Paper Exit Cover
Open this cover to remove misfed pa-
per.
9.
Ventilator
This hole helps to keep components
inside the printer from overheating.
Important
❒ Do not block or obstruct the
ventilator. A malfunction may
occur due to overheating.
10.
Front Cover Release Button
Use this button to open the front cov-
er.
11.
Power Switch
Use this switch to turn the printer
power on and off.
14
12.
Paper Tray (Tray 1)
Loads up to 500 sheets of plain paper
2
(80 g/m , 20 lb. bond) into this tray for
printing.
See "Paper and Other Media Supported
by this Printer" in the Printer Reference
on the CD-ROM labeled "Operating
Instructions".
Note
❒ Paper Tray is displayed "Tray 1"
on the panel display.
13.
Friction Pad
This is required to feed in paper one
sheet at a time. Clean the friction pad
when more than one sheet of paper is
fed into the printer. Also, replace the
friction pad when the message, "Re-
place Maintenance Kit", ap-
pears.
14.
Paper Tray Cover
Attach it when pulling out the tray ex-
tension of the paper tray.
15.
Power Cord
Plug this cord into a wall outlet.
16.
Rear Cover
Remove to install the optional Duplex
Unit or to replace the Fusing Unit.
17.
Ventilators
These holes help to keep components
inside the printer from overheating.
Important
❒ Do not block or obstruct the
ventilators. A malfunction may
occur due to overheating.
18.
Controller Board
Slide it out to install some options. At-
tach the interface cable, the network
interface cable or the 1394 interface ca-
ble to the board.