1394 Interface Unit Type 4510; Installing The 1394 Interface Unit - Ricoh AP600N Setup Manual

Installing Options

1394 Interface Unit Type 4510

Note
❒ Depending on the model you use,
the 1394 Interface Unit, the 802.11b
Interface Unit and the Bluetooth
2
Interface Unit cannot be installed
in the printer at the same time. For
more information, see p.19 "In-
stalling Options".
Important
❒ Printing using "SCSI print "(Win-
dows 2000) device and "IEEE 1394
and SCSI printers" (Windows
XP/Server 2003) with the optional
1394 Interface Unit is possible un-
der Windows 2000 and Windows
XP/Server 2003. Printing with IP
over 1394 is possible under Win-
dows Me and Windows XP/Server
2003.
❒ With Windows 2000, the 1394 In-
terface Unit can only be used with
Service Pack 1 or later. If the Ser-
vice Pack is not installed, the con-
nectable SCSI print device in a
1394 bus is only one, and the client
cannot install the printer driver
without using an account with Ad-
ministrators permission.
❒ Before touching the 1394 Interface
Unit, touch something metal to
discharge any static electricity.
Static electricity can damage the
1394 Interface Unit.
❒ Do not subject the 1394 interface
unit to physical shocks.
❒ Unplug all the interface cables
from the printer before installa-
tion. If you take out the controller
board with cables plugged in, the
1394 Interface Unit might be dam-
aged.
28
❒ Use the 1394 interface cable that
comes with this printer.
❒ Do not plug or unplug the 1394 in-
terface cable while installing the
printer driver.
Note
❒ Refer to the manual provided with
the 1394 Interface Unit for further
details.
Installing the 1394 Interface
Unit
A A A A
Check the contents of the box for
the following items:
• 1394 Interface Unit
• 1394 Interface Cable (6 pins x 4
pins)
• 1394 Interface Cable (6 pins x 6
pins)
• Installation Guide
• Notes to Users
B B B B
Be sure to check the following
points:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
Note
❒ If the Duplex Unit is not at-
tached, go to step
D
.