Ricoh AP600N Setup Manual page 62

Configuring the Printer for the Network
F F F F
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
Comm. Mode:
*802.11 Ad hoc
G G G G
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select the
transmission mode.
3
Note
❒ Default is "802.11 Ad hoc".
❒ To use an IEEE 802.11b card for
w h i c h t h e S S I D ( N e t w o r k
Name) setting is not necessary,
select "Ad hoc".
H H H H
Press { { { { Enter #} } } } .
The display returns to the previous
menu in a few seconds.
I I I I
If "802.11 Ad hoc" or "Ad hoc" is
selected for "Comm. Mode", set
the channel for transmission.
Note
❒ Check with the network admin-
istrator about the channel to
use.
A Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Channel".
IEEE 802.11b:
Channel
B Press { { { { Enter #} } } } .
The channel currently in use ap-
pears on the display.
Channel:
(1-11)
C Press { { { { U U U U } } } } or { { { { T T T T } } } } to enter the
channel.
D Press { { { { Enter #} } } } .
58
J J J J
K K K K
11
Set "Trans. Speed" in the same
way.
Note
❒ Default is "Auto". If you need to
change the transmitting speed
depending on the environment
you are using, select the appro-
priate speed.
Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "SSID", and then press the
{ { { { Enter #} } } } key.
IEEE 802.11b:
SSID
The following message appears on
the display:
SSID:
Enter ID
Note
❒ Default is "ASSID".
❒ If an SSID has been set, you can
check it. Press the { { { { U U U U } } } } or { { { { T T T T } } } }
key to display "View", and then
press the { { { { Enter #} } } } key.
A Press the { { { { Enter #} } } } key.
The following message appears
on the display:
SSID:
k
Note
❒ The value in brackets at the
upper right indicates the
number of characters en-
tered.
[ 0]