Cut Adj - Toshiba BA400 Series Key Operation Specification

8.5.24

CUT ADJ

Max.
Min. value
value
+50.0 -50.0
Notes:
1. The cut position fine adjustment value is the sum of the fine adjustment values set in the system mode
(by key operation) and set by command (from the PC). The max. value is ±50.0mm.
2. Solution for the problem with labels having label pitch of less than 22.0 mm when the disc cutter is used
The minimum label pitch of the label which can be cut in normal use is 22.0 mm. When a label having a
label pitch of less than 22.0 mm is used (although it is out of specifications), the edge of the label is
caught by the edge of the thermal head during a reverse feed to the home position after cutting a label
gap. Therefore, the label may not be fed back to the proper home position. By performing either method
below, the problem will be solved.
[Method 1] Lift the head.
When the following conditions are all met, the cut operation is performed as follows.
Head lifted  Forward feed to the cut position  Head lowered  Cut 
Head lifted  Reverse feed to the home position  Head lowered
Conditions:
* If the bottom edge of the last label advances past the feed roller while the print head is
lifted during label feed to cut, the sensor may not be able to detect an error even if the label
cannot be fed any more.
[Method 2] Adjust the cut position fine adjustment value.
Step Display
0.1 Decimal
+0.0 mm
+3.0 mm
-3.0 mm
Paper feed direction
Issue Command, Feed Command, and Eject Command received.
Label pitch of 22.0 mm, cut performed, transmissive sensor designated, cut
position fine adjustment of ±10.0 mm or less, and issue mode "C"
Integer Decimal
Sign
digit
Exist 2
Cut position
Cut position
Cut position
84
Unit of
0-padding
place measure
1 None mm