Cut/Non-Cut; Feed Mode - Toshiba B-EV4 Series Manual

Reflective sensor:
Media feed takes place according to the parameter designated by the Label
Size Set Command. However, the black mark provided on the back side of the
tag paper is automatically sensed by the reflective sensor and the stop position
is fine adjusted.
Transmissive sensor (when using normal labels):
Media feed takes place according to the parameter designated by the Label
Size Set Command. However, the label-to-label gap is automatically sensed by
the transmissive sensor and the stop position is finely adjusted.
(2)

Cut/non-cut

This option is valid in batch feed mode only. (Non-cut is selected in strip mode.)
When "with automatic forward feed standby" is set by the parameter setting and if
no subsequent command from the PC is received within 3 second after cut-
feeding, the printer automatically performs a 16.3-mm forward feed.
When the Feed Command is received in the forward feed standby state, the
printer performs a reverse feed to the original position.
* For notes, refer to the section regarding the Issue Command.
(3)

Feed mode

[C: Batch (Non-cut)]
[C: Batch (Cut)]
"Without automatic forward feed standby" selected in the system mode.
Cut position
Head position
(1) Place paper.
(2) End of feed
(Completes feeding to the top of form and stops)
Head position
(1) Place paper.
(2) End of feed (Completes feeding to the top of form)
(3) Feeds to the cut position.
(4) Cuts unnecessary paper.
(5) Feeds back to the home position.
- 136 -