Power Save Function - Toshiba BA400 Series Key Operation Specification

12 Power Save Function

1. Printer status allowing shift to the power save mode
When the following status continues for a specified length of time, the printer will enter the power save mode
and show the power save mode message. (Refer to 5. Power save mode display described below.)
However, if KB-70 is connected and the following state continues for more than the set power saving time, the
printer will be turned off.
ONLINE (Idle, communicating)
Pause
Error
Waiting for removal of a label from the media outlet
System mode (except for the menus that use the 24V line, such as self-diagnosis, test print and sensor
adjustment.)
User system mode (except for the menus that use the 24V line, such as dumping.)
Pause of the expansion I/O.
No communication with KB-70.
2. Conditions for exiting the power save mode
The power save mode is terminated when:
Printing is performed.
Key is pressed.
The status of the expansion I/O pause signal or active signal changes (because the message indicating
a pause state is displayed on the LCD.)
Printing or paper feed is initiated through the expansion I/O, or printing is caused by a release of the
printer from the pause state instructed through the expansion I/O
Commands with printer operation
The printer receives U1/U2 command (Forward feed/reverse feed command).
The printer receives T command (Feed command).
The printer receives XS command (Issue command).
The printer receives IB command (Eject command).
The printer receives RFID-related command accompanied by printer action
Auto calibration when cover is closed.
3. Display and key operations during the power save mode
When the printer enters the power save mode, it shows "POWER SAVING MODE" on the LCD and turns off
the LCD backlight. However, the operations mentioned in 6 enable the printer to display usual messages and
turn on the LCD backlight even in the power save mode. If the printer status remains unchanged for 30
seconds, "POWER SAVING MODE" is displayed and the LCD backlight turns off again.
During registration in the registration area, a message indicating power saving is displayed when no operation
is performed for 30 seconds after registration is completed.
4. LED during the power save mode
While the printer is in the power save mode, the state of the LEDs is as follows.
ONLINE LED: Flashes (ON: 1000msec. OFF: 1000msec.)
ERROR LED: OFF
150