Changing The Set Up Parameters - Raymarine RL70C Owner's Handbook Manual

122

7.2 Changing the Set Up Parameters

The set up parameters are divided into four sections:
• System, to control the aspects of the system that are not specific to the radar
or chart.
• Radar, includes bearing alignment, display preferences and the timed
transmission option.
• Advanced, to control specialist settings such as display timing, STC preset
and tune preset (see Section 7.5 for instructions on how to access these
functions).
• Chart, to control the chartplotter display, including waypoint information,
vectors and radar/chart synchronisation.
This section provides instructions for displaying and changing the default
values. The following sections list the parameters and their possible settings,
and describe the function of each parameter in turn.
➤
To set the default parameters:
1. Press the MENU key to display the set up soft keys - the options available
depend on the selected operating mode.
Radar
Chart
2. Press the soft key for the set up you require.
The requested set up menu is displayed, listing the parameters and their
current settings.
3. Use the trackpad to move the selection bar up and down the list. An arrow is
displayed at the top or bottom right-hand corner if you can scroll the list to
display further parameters.
As each line is highlighted, the soft keys are updated to show the settings
available.
- For parameters that have a numeric value, or more than four possible
settings, a scroll list is displayed above two of the soft keys.
- Some parameters are controlled by a slider that is displayed above two of
the soft keys.
HSB Series LCD Display
D3640-2
D4162-1