Moving The Cursor; Context-Sensitive Cursor Control - Raymarine RL70C Owner's Handbook Manual

Chapter 1: Overview
The cursor is used to:
• Select a position on the screen.
• Select an item, e.g. guard zone on the radar, chart object on the chartplotter.
• Select an area of the radar image to zoom into or pan the chart display.

Moving the Cursor

You can press on any of the four sections of the trackpad to move the cursor in
that direction (up, down, left or right), or press two sections at the same time to
move diagonally. The cursor moves faster as you continue to press the trackpad.
The current cursor position is shown in the cursor data box (if selected).
Note: During many operations you cannot move the cursor around the screen;
if you cannot move the cursor using the trackpad, check the default soft keys are
displayed (unless they have been switched OFF in system set up). If not, press
ENTER until they are displayed.
The cursor is normally displayed as a crosshair. However, if you have not
moved the cursor for more than five seconds, when you next move it the cursor
is outlined by a circle so it is easier to locate on the screen.

Context-Sensitive Cursor Control

The cursor is context-sensitive. When the cursor is positioned over special
features on the display a text label appears to identify the feature as follows:
Text Label
BOX
MRK
MOB
WPT
CTR
FLT
GRD
SHM
VRM/EBL
ZMB
A-B
COG
Feature
Data box (any type)
Radar Mark
Man Over Board marker
Chart Waypoint
Centre of radar
Floating EBL/VRM
Guard zone
Ships Heading Marker
VRM and EBL, 1 or 2
Zoom box
Ruler line
Course Over Ground vector
15
Radar/Chart
Both
Both
Both
Both
Radar
Radar
Radar
Radar
Radar
Radar
Chart
Chart