Changing The Set Up Parameters - Raymarine SL70M Owner's Handbook Manual

5-2

5.2 Changing the Set Up Parameters

The set up parameters are divided into four sections:
• System, to control the aspects of the system that are not specific to the
radar or chart.
• Radar, includes bearing alignment, display preferences and the timed
transmission option.
• MARPA, to control the MARPA target tracking parameters, including tar-
get vectors, safe zone and target history display.
• Advanced, to control specialist radar settings such as display timing, STC
preset and tune preset (see Section 5.6 for instructions on how to access
these functions).
Note: The GPS and Track Set Up menus are described in Chapter 6.
This section provides instructions for displaying and changing the default
values. The following sections list the parameters and their possible settings,
and describe the function of each parameter in turn.
➤ To set the default parameters:
1. Press the MENU key to display the set up soft keys - the options available
MENU
depend on the selected operating mode.
2. Press the soft key for the set up you require.
The requested set up menu is displayed, listing the parameters and their
current settings.
3. Use the trackpad to move the selection bar up and down the list. An arrow
is displayed at the top or bottom right-hand corner if you can scroll the list
to display further parameters.
As each line is highlighted, the soft keys are updated to show the settings
available.
• For parameters that have a numeric value, or more than four possible
• Some parameters are controlled by a slider that is displayed above two
• For some parameters, a soft key provides access to a sub-menu of fur-
4. Press the soft key corresponding to the desired setting or, for scroll lists, use
the soft keys to scroll forwards or backwards through the list until the
settings, a scroll list is displayed above two of the soft keys.
of the soft keys.
ther options.
SL70M & SL70C PLUS Pathfinder Radar Displays
D3640-3