Man Overboard (Mob) - Raymarine RL70C Owner's Handbook Manual

116

6.4 Man Overboard (MOB)

If you lose a person or object overboard, and need to return to the location, you
should use the Man Overboard (MOB) function.
You can select the type of data used for the MOB position using the set up
menus (see Chapter 7).
Note: To obtain MOB position, you need either of the following:
• Position data from a GPS or equivalent device
• Heading and speed data, so that the position can be calculated by dead
reckoning
➤ To initiate the MOB procedure, press and hold the MARKS key for two
seconds. The system then performs the following tasks automatically:
• Redraws the chart at 1/2 nm (even if cartography is not availabe but plotter
mode is on).
• Marks the current position with a MOB symbol
current active waypoint and route.
• Displays the MOB data box, showing the bearing and distance from your
vessel to the MOB waypoint position, and the elapsed time since the MOB
was initiated.
• As your vessel moves from the MOB position, a dotted line is displayed
connecting the MOB symbol and the vessel's current position.
• Sounds a 4-second alarm pattern every 30 seconds.
• Sends an MOB message (including bearing and distance) to other units in the
system, via the SeaTalk connection.
➤ To cancel the MOB, press and hold the MARKS key for 2 seconds.
The chart is re-drawn at its previous scale, and the MOB symbol and data box
are removed.
Note: The MOB procedure can also be initiated or cancelled if the appropriate
SeaTalk message is received by the display unit.
which replaces any
MOB data box
HSB Series LCD Display
MOB position
D4273-1