Changing Quantum Radar Channel - Raymarine QUANTUM 2 Installation Instructions Manual

LightHouse™ 4 connection screen:
Important:
• Ensure that the SSID and Passcode are entered exactly as shown on the
serial number label that was supplied with the Radar.
• The SSID is always made up of the word "Quantum", followed by an
underscore "_", followed by the product's 7 digit serial number, (e.g.
Quantum_1234567).
7. Select [Connect].
The initial connection can take up to 2 minutes to complete. If the
connection does not complete within 2 minutes, power cycle the Radar
and repeat Steps 4 to 7.
8. Select [OK] from the Successful Connection pop-up.
9. Open a Radar application page.
10. Check that the reported Radar on the power / transmit pop-up is the
Radar that you have just paired with.
11. If the correct Radar is reported, select [Tx] (Transmit).
12. If the reported Radar is not the Radar scanner you just paired with, select
the correct Radar from the Radar application menu: [Menu > Select
Radar:] and then select [Tx] (Transmit).
60
The Radar image can be displayed on all networked MFDs.

Changing Quantum radar channel

In rare circumstances Radar noise which cannot be eliminated using the
Radar app's [Sensitivity] settings may be fixed by changing the Radar's
internal wired adaptor channel.
Note:
• This feature requires Quantum 2 software version 2.50 (or later) /
Quantum software version 2.44 (or later) and LightHouse™ 4 MFD
software version 4.3.54 (or later).
• In the first instance you should try adjusting [Sensitivity] settings to
eliminate the noise before changing the [Wired adaptor channel].
Follow the steps below to change the channel from your display:
1. Select the [Installation] tab from the Radar app menu: ([Menu > Settings >
Installation]).
2. Select the [Wired Adapter Channel] field.
3. Change the channel to a different number.
4. Reboot the Radar scanner for the changes to take effect.