14
ELECTRICAL SYSTEM
14.1
Removing the battery
Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
14.2
Installing the battery
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Disconnect negative cable
–
Pull back positive terminal cover
battery.
–
Remove screw
–
Pull holding bracket
F00138-10
Main work
–
Insert the battery into the battery compartment with the terminals facing forward
and secure with holding bracket
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Connect positive cable
Guideline
Screw, battery terminal
–
Connect negative cable
Guideline
Screw, battery terminal
Contact disks
H00386-10
the claws toward the battery terminal.
–
Slide positive terminal cover
Finishing work
–
Mount the seat. (
1 m (3 ft)
9 V
p. 49)
1
from the battery.
2
and disconnect the positive cable from the
3
.
4
forward and remove battery toward the top.
1
.
p. 102)
2
.
3
to the battery.
4
to the battery.
A
must be mounted under screws
7
over the positive terminal.
p. 49)
M6
10 Nm (7.4 lbf ft)
M5
2.5 Nm
(1.84 lbf ft)
M5
2.5 Nm
(1.84 lbf ft)
5
and cable sockets
78
6
with