11
SERVICE WORK ON THE CHASSIS
11.34
Checking for chain dirt accumulation
(All SX‑F models)
–
Mount and tighten screw
Guideline
Remaining screws, chassis
S01242-11
–
Plug in connector
–
Remove the wash cap set. Thoroughly clean the plug-in connection of the fuel
line using compressed air.
–
Lubricate the O-ring and connect plug-in connection
V00293-11
(XC‑F US)
–
Mount and tighten screw
Guideline
Remaining screws, chassis
S01248-11
–
Plug in connector
–
Remove the wash cap set. Thoroughly clean the plug-in connection of the fuel
line using compressed air.
–
Lubricate the O-ring and connect plug-in connection
V00316-11
Finishing work
–
Mount the seat. (
–
Check the chain for coarse dirt accumulation.
»
If the chain is very dirty:
–
Clean the chain. (
400678-01
2
with the rubber bushing.
3
for the fuel pump.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve!
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.
2
with the rubber bushing.
3
for the fuel pump.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve!
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.
p. 49)
p. 57)
M6
10 Nm
(7.4 lbf ft)
4
for the fuel line.
M6
10 Nm
(7.4 lbf ft)
4
for the fuel line.
56