Table of Contents
Advertisement
9
SERVICE SCHEDULE
Check the fuel pressure.
Check idle.
Final check: Check the vehicle for safe operation and take a test ride.
Read out the fault memory using the KTM diagnostics tool after a test ride.
Make the service entry in the KTM Dealer.net and in the Service and Warranty Booklet.
○
One-time interval
●
Periodic interval
9.3
Recommended work
Change the front brake fluid.
Change the rear brake fluid.
Change the hydraulic clutch fluid.
Grease the steering head bearing.
Service the fork.
Service the shock absorber.
Change the fuel filter.
Perform minor engine service, engine has been installed. (Change spark plug and spark plug connector.
Change piston, check and measure cylinder; check cylinder head. Check the camshaft, rocker arm and
rocker arm shafts. Check timing assembly.)
Perform major engine service including removing and installing engine. (Change valves, valve springs,
valve spring seats and valve spring retainers. Change the connecting rod, conrod bearing, and crank pin.
Check the transmission and shift mechanism. Check the oil pressure regulator valve. Change the suction
pump. Check the force pump and lubrication system. Change timing chain. Change all engine bearings.
Change the shaft seal rings and bearing seals of the main bearing.)
○
One-time interval
●
Periodic interval
(
p. 62)
(
p. 45)
Every 30 operating hours
Every 20 operating hours
Every 10 operating hours/after every race
Once after 1 operating hour
Every 100 operating hours
Every 50 operating hours
Once after 20 operating hours
Once after 10 operating hours
28
Every 40 operating hours
●
●
●
●
○
●
●
●
●
○
●
●
●
●
○
●
●
●
●
○
●
●
●
●
Annually
●
●
●
●
○
○
●
●
●
●
Advertisement
Table of Contents
