KTM 450 SX-F 2018 Owner's Manual page 50

11 SERVICE WORK ON THE CHASSIS
–
Position the swingarm and mount the swingarm pivot.
Info
Pay attention to flat area
–
Mount and tighten nut
Guideline
Nut, swingarm pivot
V00292-10
–
Mount the chain.
–
Connect the chain with connecting link
Guideline
The closed side of the chain joint lock must face in the direction of travel.
S01222-11
–
Position the foot brake cylinder.
Push rod
Info
Ensure that the dust boot is correctly seated.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
S01228-10
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever to angle lever
Info
Pay attention to flat area
–
Mount and tighten screw
S01229-10
Guideline
Screw, bottom shock
absorber
Info
Raise the wheel slightly to be able to mount the screw more easily.
–
Position the frame protectors on the left and right.
–
Mount and tighten screws
Guideline
Screw, frame protector
–
Mount and tighten screws
Guideline
Screw, frame protector
V00291-11
–
Mount the new cable ties.
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
A
.
2
.
3
4 engages in the foot brake cylinder.
5
.
6
.
B .
7
.
M10
8 with the washers.
9
.
M16x1.5 100 Nm
(73.8 lbf ft)
.
M6 10 Nm (7.4 lbf ft)
M14x1.5 80 Nm (59 lbf ft)
60 Nm Loctite
(44.3 lbf ft)
M5 3 Nm (2.2 lbf ft)
M5 3 Nm (2.2 lbf ft)
p. 68)
p. 39)
48
® 2701™