16
TUNING THE ENGINE
16.4
Changing the mapping
Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the TC button.
The mapping can also be changed during the ride.
16.5
Adjusting the idle speed
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized KTM workshop will be glad to help.)
–
Clean the outside of the handlebar and the inside of the grip tube. Mount the grip
tube on the handlebar.
–
Attach the throttle cables to the guide plate and route correctly.
–
Position half-shells
Guideline
Screw, throttle grip
–
Slide on sleeve
F00131-10
Finishing work
–
Check the play in the throttle cable. (
Activating STANDARD mapping:
–
Press button MAP until LED 1 lights up.
Guideline
Engine speed
STANDARD – balanced response
H01180-10
Activating ADVANCED mapping:
–
Press button MAP until LED 2 lights up.
Guideline
Engine speed
ADVANCED – direct response
H01180-11
3
, mount and tighten screws
1
and check the throttle grip for ease of movement.
p. 84)
2
.
M6
5 Nm (3.7 lbf ft)
< 4,000 rpm
< 4,000 rpm
86