Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
F00158-10
(All SX‑F models)
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
Mount bleeding syringe
–
Only loosen bleeder screw
filling is possible.
V00295-10
(XC‑F US)
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
Mount bleeding syringe
–
Only loosen bleeder screw
filling is possible.
F01053-10
–
Now inject the liquid into the system until it emerges from drill hole
master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
–
Tighten the bleeder screw and remove the bleeding syringe with the hose.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
F00166-10
1
.
2
3
with membrane
.
4
with the appropriate hydraulic fluid.
4
on bleeder screw
5
on the clutch slave cylinder to the point where
Info
Clean up overflowed or spilled brake fluid immediately with water.
Avoid contact between brake fluid and painted parts. Brake fluid attacks
paint.
Only use clean brake fluid from a sealed container.
4
with the appropriate hydraulic fluid.
4
on bleeder screw
5
on the clutch slave cylinder to the point where
Info
Clean up overflowed or spilled brake fluid immediately with water.
Avoid contact between brake fluid and painted parts. Brake fluid attacks
paint.
Only use clean brake fluid from a sealed container.
p. 107)
5
using a fitting section of hose.
p. 107)
5
using a fitting section of hose.
4 mm (0.16 in)
63
6
of the
Advertisement
Table of Contents
