11
SERVICE WORK ON THE CHASSIS
11.39
Checking the frame
11.40
Checking the swingarm
11.41
Checking the throttle cable routing
–
Check the chain guide with a slide gauge for dimension
Minimum thickness
guide
»
If the measured value is less than the specification:
–
Change the chain guide.
402421-10
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
102192-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracks and deformation.
»
If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame.
F01029-01
–
Check the swingarm for damage, cracking, and deformation.
»
If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm.
401520-01
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
C
of the chain
Info
Always replace a frame that has been damaged due to a mechanical
impact. Repair of the frame is not authorized by KTM.
Info
Always change a damaged swingarm. Repair of the swingarm is not
authorized by KTM.
p. 49)
(
p. 53)
C
.
6 mm (0.24 in)
M6
10 Nm
(7.4 lbf ft)
p. 39)
60