17
SERVICE WORK ON THE ENGINE
–
Position oil screen
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
V00306-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
Guideline
Oil drain plug with magnet
V00307-10
–
Remove screws
102237-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
V00308-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the housing.
–
Oil the O-ring of the oil filter cover and mount it together with oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
V00309-10
–
Remove filler plug
with engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil will result in premature wear
of the engine.
–
Mount and tighten the filler plug together with the O-ring.
401955-12
4
with the O-rings on a pin wrench.
3
with the O-ring.
1
with the magnet and a new seal ring.
5
. Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
8
from the clutch cover together with the O-ring, and fill up
1.20 l (1.27 qt.)
M20x1.5
15 Nm
(11.1 lbf ft)
M12x1.5
20 Nm
(14.8 lbf ft)
M6
10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
92
7
.
p. 107)