Table of Contents
Advertisement
Gas Section
GAS INSTALLATION REQUIREMENTS
Important !
Before installation, make sure that the local distribution conditions (gas
•
type and pressure) and the adjustment of this appliance are compatible. The
appliance adjustment conditions are given on the plate or the label.
This appliance must be installed and serviced only by a suitably qualified,
•
registered installer with technical knowledge of both gas installation and
electricity. The installation or service must comply with the current editions of
the applicable standards, regulations, and codes of practice governing gas and
electrical installations.
Failure to install the appliance correctly could invalidate any manufacturer's
•
warranty.
This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached
on the appliance).
Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only and cannot
•
be used on any other gas (LPG) without modification. The appliances are manufactured for
conversion to LPG.
Appliances supplied for use on LPG: they are adjusted for this gas only and cannot be used
•
on any other gas (NATURAL GAS) without modification. The appliances are manufactured for
conversion to NATURAL GAS.
If the NATURAL GAS/LPG conversion kit is not supplied with the appliance this kit can be purchased
by contacting the After-Sales Service.
INSTALLATION & SERVICE REGULATIONS
It is a legal requirement that all gas appliances are Installed & Serviced by a competent person in
accordance with the current editions of the following Standards & Regulations or those regulations
appropriate to the geographical region in which they are to be installed:
Gas Safety (Installation & Use) Regulations
•
Building Regulations
•
British/European Standards
•
Regulations for Electrical Installation
•
Installation and service of any gas product must be made by a suitably qualified and registered
person competent on the type of product being installed or serviced and holding a valid certificate
of competence for the work being carried out. Currently the proof of competence is the Accredited
Certification Scheme (ACS) or N/SVQ that has been aligned to the ACS.
It is also a requirement that all businesses or self employed installers are members of a class of
person approved by the Health and Safety Executive.
Failure to install the appliance correctly could invalidate any manufacturers warranty and lead to
prosecution under the above quoted regulations.
13
Advertisement
Table of Contents
