Table of Contents
Advertisement
GAS TAPS
•
Do not let cleaning products come into contact with the valves.
•
Periodic lubrication of the gas taps must be carried out by specialist personnel only.
•
In the event of operating faults in the gas taps, call the Service Department.
BURNERS
These parts must be cleaned using a sponge and soapy water or other suitable non-abrasive
products. Dry with a soft cloth.
Warning! Not dishwasher safe.
After cleaning, the burners and their flame spreaders must be well dried and correctly replaced.
It is very important to check that the burner flame spreader and the cap have been correctly
positioned. Failure to do so can cause serious problems.
Check that the electrode/s "
trouble-free sparking.
Check that the probe/s "
operation of the safety valves.
Both the probe and ignition plug must be very carefully cleaned.
Note: To avoid damage to the electric ignition do not use it when the burners are not in
place.
Note: Continuous use may cause a change in the glaze around the burners and grids,
corresponding to the areas exposed to the heat. This is a natural phenomenon and does
not prevent the parts from working properly.
CORRECT REPLACEMENT OF THE AUXILIARY and SEMI-RAPID BURNER
It is very important to check that the burner flame distributor "
correctly positioned (see figs. 7, 8) - failure to do so can cause serious problems.
CORRECT REPLACEMENT OF THE TRIPLE-RING AND DUAL BURNER
The burner must be correctly positioned; failure to do so can cause serious problems.
Fit the flame spreader to the housing as shown by the arrows (see figs. 9, 10).
The burner correctly positioned must not rotate (fig. 11).
Then position the cap "
S
" (figs. 7, 9, 10) next to each burner is/are always clean to ensure
T
" (figs. 7, 9, 10) next to each burner is/are always clean to ensure correct
A
B
" and the ring "
" (figs. 11, 12).
F
C
" and the cap "
" have been
29
Advertisement
Table of Contents
