FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening the
cooktop to benches from 30 to 40mm thick.
The kit includes two "F" type brackets (for the front of the cooktop), two "R" type brackets (for the
rear of the cooktop) and four self-threading screws "S".
Cut the unit according to the dimensions in fig. 2a.
•
•
Stretch gasket "G" over the edge of the hole made, being careful to overlay the junction
edges.
–
Fasten the brackets "F" and "R" to the appropriate socket holes, without tightening the screws
"S" for the moment. Make sure that the tabs are mounted correctly, as shown (figs. 2b, 2c).
Rotate the tabs so that the cooktop can be put into the cutout.
–
Put the cooktop into the cutout and position it correctly.
–
Put the brackets "F" and "R" into place; tooth "A" of the brackets should go into the hole (figs.
2b, 2c).
–
Tighten screws "S" until the cooktop is completely secured to the bench.
–
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop.
Take care not to damage the workbench.
Rear Fixing Brackets
Fig. 2b
G
R
Fig. 2a
Fig. 2c
A
S
R
R
F
Front Fixing Brackets
A
S
F
G
F
11
R