CDA HG7501 Series Instructions For Installation, Use And Maintenance Manual page 19

Mains Electricity Connection
Incorrect installation may be dangerous and the manufacturer can not be held responsible.
Warning! This appliance must be earthed The manufacturer declines all responsibility for
any problem caused by failure to observe this rule.
THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING
FIXED WIRING VIA A DOUBLE POLE SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 3A FUSE.
We recommend that the appliance is connected by a qualified electrician, who is a member of the
N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations.
The wires in the mains lead of this appliance are coloured in accordance with the following code:
Green & Yellow = Earth, Blue = Neutral, Brown = Live.
As the colours of the wires in the mains lead for the appliance may not correspond with the
coloured markings identifying the terminals
connecting to the fuse spur, proceed as follows:
The wire which is coloured green and yellow
•
must be connected to the terminal marked
E (Earth) or coloured green.
The wire which is coloured blue must
•
be connected to the terminal marked N
(Neutral), or coloured black.
The wire which is coloured brown must be
•
connected to the terminal marked L (Live),
or coloured red.
Note: Use a 3A Fuse
Assembly and electrical connection should be
carried out by specialised personnel.
When installing this product we recommend you
seek the help of another individual.
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
ON
FUSE
USE A 3 AMP FUSE
Fig. 7
19