16
Fastening the Cooktop
Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop
to benches from 30 to 40 mm thick.The kit includes four R brackets and four self-threading screws S (figs.
19, 20).
– Cut the unit according to the dimensions in fig. 16.
– Turn the hob upside down and rest the glass side on a soft surface.
– Spread the seal G around the edge of the hob (fig. 19).
– Fasten the brackets R to the appropriate socket holes, without tightening the screws S for the moment.
Make sure that the tabs are mounted correctly, as shown. Rotate the tabs so that the cooktop can be
put into the cutout.
– Put the cooktop into the cutout and position it correctly.
– Put the brackets R into place; tooth A of the brackets should go into the hole (Fig. 20).
– Tighten screws S until the cooktop is completely secured to the bench.
– Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop.
Take care not to damage the workbench.
Fig. 19
G
Fig. 20
R
G
Adhesive side
A
R
S
R