Installation; Attaching The Strain-Relief Bracket - Enterasys Matrix E1 Series Installation Manual

Installation

3.7.1.2 Installation
Rack mounting the device involves the following:
•

Attaching the strain-relief bracket

•
Rack mounting the device (attaching the mounting brackets and fastening the device to the rack)
3.7.2 Attaching the Strain-Relief Bracket
To attach the strain-relief bracket to the device, refer to
1. Locate the strain-relief bracket
device.
CAUTION: Do not attempt to attach the strain-relief bracket with screws other than the
M4 x 6 mm screws included with the device. Use of longer screws may damage the unit.
2. Place the device upside down (as shown in
strain-relief bracket
Figure 3-9 Attaching the Strain-Relief Bracket
➀
Strain-relief bracket
3-16 Hardware Installation
➀
and four M4 x 6 mm pan-head screws
➀
to the bottom of the device using the four M4 x 6 mm pan-head screws
1 1
C O M
R E S E T
C P U
P W R
1 G 5 8 2 - 0 9
Figure 3-9
Figure 3-9) on a clean flat surface. Then attach the
Á
À
2 2 3 3 4 4
➁
M4 x 6 mm pan-head screws
and proceed as follows:
➁
shipped with the
5 5 6 6
➁
.