Installation; Unpacking The Module; Installing Options Into The 6G306-06; Contents Of The Module Carton - Enterasys SmartSwitch 6G302-06 Installation Manual

Unpacking the Module

3.1 UNPACKING THE MODULE
Unpack the module as follows:
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in
Table 3-1 Contents of the Module Carton
Item
6G302-06 or 6G306-06
Antistatic Wrist Strap
Manual Accessory Kit
3. Remove the tape seal on the non-conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to
3.2

INSTALLING OPTIONS INTO THE 6G306-06

You may install any optional GPIM into the 6G306-06 before proceeding to
may be installed before or after the module is installed into the chassis, as they are hot-swappable.
If you install the module before installing GPIMs, return to this section to install GPIMs in the
module, as improper installation can result in damage to either the GPIM or the module.
NOTE: If you are installing a 6G302-06, proceed to
Section 3.2
NOTE: If the module is to be installed with an optional FLASH upgrade, refer to
Appendix B
There are two different physical styles of GPIMs that can be installed into the module, as seen in
Figure 3-1. One style has the squeeze latch side clips
Section 3.2.1. The other style is the locking bar
Section 3.2.2.
3-2

Installation

for instructions on installing various options into the 6G306-06.
before installing the module into the chassis.
Table 3-1.
Quantity
1
1
1
"Getting Help"
Section
(Figure 3-1, View A), with the procedure in
(Figure 3-1, View B), with the procedure in
for details.
Section 3.3. GPIMs
3.3. Otherwise, proceed to