3. Push the release tabs
simultaneously lift the DRAM SIMM enough to release it from the connector
4. Rotate the DRAM SIMM ➁ upwards as shown in
connector ➂.
Figure B-4 Removing the Existing DRAM SIMM
À
➀
Release tabs
B.4.3
Installing the DRAM SIMM
CAUTION: Observe all antistatic precautions when handling sensitive electronic
equipment.
To install a DRAM SIMM, refer to
1. With the SIMM alignment notch
between the connector fingers
2. Pivot the SIMM
➄
notches
and the connector clips lock the SIMM into place.
➀
away from the DRAM SIMM
➁
DRAM SIMM
Figure B-5
➀
oriented as shown in
➂
.
➁
downward so the connector clips
Optional Installations and Mode Switch Bank Settings
➁
, as shown in
Figure B-4
and remove it from the
Â
Á
À
➂
and proceed as follows:
Figure
➃
align with the two SIMM alignment
SIMM Replacement Procedure
Figure B-4
and
➂
.
Connector
B-5, insert the SIMM
➁
down
B-7