Installing The Device - Enterasys Matrix E1 Series Installation Manual

Removing the Mini-GBIC
Removing the Mini-GBIC
CAUTION: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab
located under the front bottom end of the Mini-GBIC
The Mini-GBIC, 1G-2MGBIC, and 1G58x-09 are sensitive to static discharges. Use an
antistatic wrist strap and observe all static precautions during this procedure. Failure to
do so could result in damage to the Mini-GBIC, 1G-2MGBIC, or 1G58x-09. Always leave
the Mini-GBIC in the antistatic bag or an equivalent antistatic container when not
installed.
To remove a Mini-GBIC from the 1G-2MGBIC, refer back to
appropriate, and proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC.
2. Remove the cables connected to the Mini-GBIC.
3. Locate the locking tab
far as it will go to release the Mini-GBIC from the 1G-2MGBIC
4. Grasp the sides of the Mini-GBIC
If storing or shipping the Mini-GBIC, insert the dust protector into the Mini-GBIC to protect the
fiber ports.
3.7

INSTALLING THE DEVICE

For a tabletop or shelf installation, locate the device within seven feet of its power source and on an
unrestricted free surface area as shown in
instructions.
CAUTION: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in) at the left, right, and rear of the device.
3-14 Hardware Installation
➅
under the front end of the Mini-GBIC
➀
and pull it straight out of the 1G-2MGBIC
Figure
.
This can damage the Mini-GBIC.
Figure 3-6
➀
3-8. Proceed to Section 3.7.4
or Figure 3-7 as
. Push in on the locking tab as
➃
.
➃
.
for power connection