Installing the Locking Bar GBIC
2. Lift the metal locking bar
the GBIC clips.
➀
3. Hold the GBIC
➅
connector
should be facing towards the empty port slot
adjacent to the door hinge of the port slot door.
4. Align the GBIC alignment slots
into the slot.
CAUTION: If, in the following step, the GBIC does not insert easily and stops about one
quarter of the way into the slot, do not try to push it in any further. Remove and check
the orientation against
20-pin port engages with the connector in the port slot.
➀
5. Push the GBIC
➇
slot
.
Figure 3-5 GBIC Metal Locking Bar Positions
A
Â
B
➀
GBIC
➁
Top of GBIC
➂
Metal locking bar (up position, unlocked)
➃
Network port
➄
1G-2GBIC (Ethernet expansion module)
3-10
Hardware Installation
➂
upwards as far as it will go. See
with the network port
➆
with the card guides inside the port slot
Figure
3-5. Try again to push the GBIC into the slot until the
back until the 20-pin connector port
À
Á
È
➃
facing away from the 1G-2GBIC
➇
➅
engages with the connector in port
Ç
Ä
➅
20-pin connector (insertion side)
➆
Alignment slots
➇
Port slot
➈
Metal locking bar (down position, locked)
Figure
3-5, View A. This unlocks
➄
. The 20-pin
. The top of the GBIC
➇
. The door folds up
1G-2GBIC
Å
Æ
Ã
➁
must be