Enterasys Matrix E1 Series Installation Manual page 88

SIMM Replacement Procedure
Figure B-5 Installing the DRAM
Ä
➀
SIMM alignment notch
➁
SIMM
3. Reconnect the device to the network as follows:
a. Reinstall the device into the rack if necessary.
b. Reinstall the top cover.
c. Reconnect the network cables to the device.
d. Reconnect both power cords from the rear of the chassis to the ac power outlets.
This completes the replacement of the DRAM SIMM.
B-8 Optional Installations and Mode Switch Bank Settings
Ã
Á
➂
Connector fingers
➃
Connector clips
Â
Ã
À
Ä
➄
SIMM alignment notches (2)